After Using Last Known Good Configuration Windows 7 Will Pc Boot Ok Again
starting time: go to start, right click on My computer, choose avant-garde tab, go to the section for startup and recovery, settings, then place a check in write an event into system log, uncheck send admin alert, and uncheck automated restart, and so from the drop downwardly listing under debugging, choose small memory dump.
then you lot can reboot.
If, hopefully not, the pc does not offset up you volition want to run the recovery console and run
chkdsk c: /r
Here'south how to make a bootable xp recovery console cd
Courtesy of JoseIbarra
You demand to start by booting into the XP Recovery Console using a CD yous can make (no XP media required) and run a chkdsk with error correction enough times until information technology runs make clean and if that doesn't work, you tin create a new boot.ini file (information technology is usually ane of those two things).
Here'south how:
Utilise the XP Recovery Console to verify the file system on your HDD and correct any problems and then try to boot your system - this may exist all you need to do. Or, y'all are welcome to just start trying things that might work.
Boot into the Windows Recovery Panel using a bootable XP installation CD.
If you have no bootable XP media (or are not sure what you accept) create a bootable XP Recovery Console CD and be sure what yous have (no XP media required).
This is non the same as any recovery disks that might have come with a shop bought system.
You can make a bootable Recovery Console CD past downloading an ISO file and burning information technology to a CD.
The bootable ISO paradigm file you need to download is chosen:
rc.iso
Download the ISO file from here:
http://www.thecomputerparamedic.com/?p=8 (courtesy of Daavee)
Use a new CD and this costless and easy program to fire your ISO file and create your bootable CD:
http://world wide web.imgburn.com/
When installing ImgBurn, DO NOT install the Inquire toolbar.
Hither are some instructions for ImgBurn:
http://forum.imgburn.com/alphabetize.php?showtopic=61
Information technology would be a good idea to test your bootable CD on a computer that is working.
You may need to adjust the computer BIOS settings to use the CD ROM drive as the first boot device instead of the hard disk. These adjustments are made earlier Windows tries to load. If you miss it, you will have to reboot the organization once again.
When you boot on the CD, follow the prompts:
Press any key to kicking from CD...
The Windows Setup... will proceed.
Press 'R' to enter the Recovery Console.
Select the installation you want to admission (unremarkably 1: C:\WINDOWS)
You may be asked to enter the Administrator password (usually empty).
You should be in the C:\WINDOWS folder. This is the aforementioned as the
C:\WINDOWS folder you come across in explorer.
The Recovery Console allows basic file commands like: re-create, rename, replace, delete, cd, chkdsk, fixboot, fixmbr, etc.
For a list of Recovery Console commands, enter assist at the prompt or read about the XP Recovery Console hither:
http://www.microsoft.com/resources/documentation/windows/xp/all/proddocs/en-us/recovery_console_cmds.mspx?mfr=true
A skillful idea before starting things is to first verify the integrity of your file organisation using the chkdsk command.
From the command prompt window run the chkdsk command on the drive where Windows is installed to endeavour to repair any issues on the affected drive.
Running chkdsk is fine even if it doesn't observe any problems. It will non hurt anything to run information technology.
Assuming your boot drive is C, run the following command:
chkdsk C: /r
Let chkdsk finish and correct any problems it might find.
Information technology may take a long fourth dimension for chkdsk to consummate or information technology may appear to be 'stuck'. Be patient. If the HDD light is still flashing, chkdsk is doing something. Keep an heart on the percent corporeality to be sure it is all the same making progress. It may even appear to go backwards sometimes.
Yous should run chkdsk /r again until it finds no errors to correct.
Remove the CD and type 'exit' to leave the RC and restart the calculator.
You lot do not take to adjust the BIOS once more to boot on the HDD since the CD will non be nowadays.
-------------------------------------------
if you accept sata drives y'all will have to modify the bios to IDE or you would have to burn Hiren's kicking cd, permit me know if you need the instructions for this.
Dell Dimension 3000, Firefox, WinXP Pro/Sp3, 360 TSE by Qiho, MBAM
Was this reply helpful?
Thank you - I'll effort that when I get home tonight. Don't surrender on me due to a delayed respond. I'm at work now.
( Ironically, I have what I thought was an emergency bootable system recovery deejay created when I installed Norton Ghost to do regular backups. And the BIOS is gear up to bank check for a bootable CD beginning. Imagine what I was thinking when the PC wouldn't boot from the CD! Bad words. )
Was this reply helpful?
Acronis True prototype is the one you lot want. Volition bank check back later.
Dell Dimension 3000, Firefox, WinXP Pro/Sp3, 360 TSE by Qiho, MBAM
Was this reply helpful?
While at work, Windows automatically downloaded and installed some updates from MS, then rebooted. I saw the login screen when I turned the monitor on. Simply I logged in without incident. I looked at those My Calculator>Properties>Settings and they were mostly already there, with the exception of un-checking the send admin warning pick. And so, information technology seems as if Windows is going to continue downwards the safe path each fourth dimension I reboot? Was this a erstwhile fluke that I can ignore, or should I run chkdskin on the C drive with /r (repair) enabled? In the very to the lowest degree, I'yard going to create the new bootable CD you lot recommended. Yes my hard drives are connected with SATA cables (red, 1/4 inch wide), is that the config that requires I change the BIOS to IDE? I've been in the BIOS several times merely want to exist certain I know which panel has the IDE pick.
Was this reply helpful?
Sata is not my forte, so instead of changing, I will give you the instructions to fire Hiren'south boot cd, equally it does not care if it is Sata or IDE:
one. yep, information technology is a good idea to run checkdisk every now and so: chkdsk c: /r
ii.
Courtesy of Jose Ibarra:
Anywho, to make a Hiren'southward boot CD, do this:
I am going to recommend you use Hiren'due south boot CD (it will also keep a USB bulldoze).
This is salubrious considering it has many more than tools on it that on the XP Recovery Console CD, does non care about your Administrator passwords and you lot will not have to futz around in your BIOS if any afflicted system has SATA drives - Hiren's can bargain with that.
You will have a whole bunch of cool tools that you don't have in the XP Recovery Console... a registry editor, password resetter, and a desktop that looks like Windows XP so y'all will feel comfortable maneuvering.
Yous can also easily copy your personal data (documents, images, music.) to an external drive.
From a working system, get-go download Hiren's Kick CD from here (it is a substantial download only worth it):
http://www.hirensbootcd.org/download/ (wait near the bottom of the folio, exercise not click on whatsoever ads).
Unzip the Hiren'due south to some binder where you can find it. There is a Hiren's.BootCD..iso in there that yous are going to demand next.
Hiren's has instructions to brand a bootable USB that y'all can use, but it requires y'all to first fire the .iso to a CD and some other steps, so I suggest another way...
Download RUFUS 1.20 from here (read some stuff on the page so you can know more virtually it):
http://rufus.akeo.ie/
I will caution y'all to be conscientious that you don't accidentally format any of your difficult drives - be certain your USB stick is in and know what the drive letter is! This part always makes me a lilliputian nervous, so be conscientious.
Launch RUFUS and all the defaults should exist okay, for the Device, cull your USB drive letter, Quick format, FAT32, characterization information technology if you want to and in the Format options box, click the footling icon that looks like a CD and a window will open up. Navigate that dialogue to betoken to the binder that contains the Hiren's.BootCD.15.iso that you unzipped earlier and the box should change to say ISO image (RUFUS understands the Hiren's ISO file).
Double check you have the correct Device selected in the top (Non you HDD) Click Get-go, acknowledge the warning and let information technology terminate (it will take a piddling while) every bit it copies the files. The Hiren's ISO is as well good size.
When RUFUS is done, it will say 'Done' in the bottom.
Put the USB stick in the afflicted machine and reset/reboot and press whatever key you need to press to get to a boot menu where yous tin select the USB every bit the offset boot device (that is F11 for me). If you lot don't run into a boot card pick, you will take to adjust your BIOS to boot from the USB outset instead of the HDD.
When the Hiren'due south menu comes up, choose the Mini XP Mode and information technology will beginning loading (slowly from a USB drive) and eventually you should see a Windowsy looking desktop. You should recognize that part and feel comfortable, but information technology is not your desktop - it is the Hiren's desktop!
Call back: You did not kick on your hard disk - you booted into the Hiren's desktop
-----------------------------------------
so far so practiced. awaiting whatsoever updates.
Dell Dimension 3000, Firefox, WinXP Pro/Sp3, 360 TSE by Qiho, MBAM
Was this reply helpful?
OK, I'll download Hiren's boot CD and do some testing. Thanks so much!
Was this reply helpful?
ok, volition cheque back.
Dell Dimension 3000, Firefox, WinXP Pro/Sp3, 360 TSE past Qiho, MBAM
Was this reply helpful?
Source: https://answers.microsoft.com/en-us/windows/forum/all/safe-to-reboot-after-using-last-known-good/0cb1c7ef-29ee-4c7b-a954-085a45d2a94d
0 Response to "After Using Last Known Good Configuration Windows 7 Will Pc Boot Ok Again"
Post a Comment